9 Signs Your Water Heater Is About To Burst And Flood Your Basement
3 mins read

9 Signs Your Water Heater Is About To Burst And Flood Your Basement

Water heaters are a vital part of your home. But despite the comfort and efficiency they provide, they also give you that risk of bursting and flooding the area where it’s located — i.e., your basement.

When this happens, you need to get help from companies that offer water damage restoration, Baltimore, Maryland services. These restoration experts don’t only clean up your place and get rid of water, they also ensure that your place is free of health hazards brought about by the flooding.

However, more than anything else, preventing to reach that scenario should be your priority. In this article, we’re rounding up nine signs that your water heater is about to get broken and flood your basement.

There is water leakage. If you see water leaking from your water heater, it should be your priority to get to the root of the problem and subsequently address it. Water leakage can be caused by the tank’s temperature-and-pressure valve unleashing excess steam or the tank leaking internally.

There’s a presence of corrosion. This condition is commonly referred to as “slow leak.” Corrosion around the tanks pipe fittings can be attributed to the water’s mineral deposits seeping out through the gaps found in these pipe connections.

The flame under the tank becomes yellow. The usual color of the flame underneath your tank should be blue. If it becomes yellowish, it indicates that your burner is broken and needs to be serviced immediately.

You notice burn marks. Water damage restoration, Baltimore, Maryland experts regard burn marks as a serious concern that requires a prompt solution. Burn marks found at the bottom of the tank can be traced to damaged flue pipes or natural gas and exhaust fumes not properly exiting your basement.

You hear an unusual noise. Once your water heater starts to give out popping sounds, it means that there’s something wrong with your water heater. This sound comes from the water that gets trapped under the layer of sediment that has built up at the bottom of the tank.

Your hot water runs out quicker than usual. If your hot water runs out more quickly than usual, it could mean that your tank’s heating element is damaged or there’s too much sediment build-up.

The water is rusty. Tanks that are made of steel are bound to rust at one point in the future. This will eventually be observed in the water that will come out on your faucet and shower.

Your smell a pungent odor. When your water tank has an internal gas leak, it can also produce a pungent odor similar to a rotten egg. When you smell this one, immediately turn the gas off and call for a professional.

Your tank is not properly installed. Though this one is hard to detect if you’re not a prof, faulty installation is also often cited by water damage restoration, Baltimore, Maryland experts as a prime cause of water heater burst. This can also lead to explosion and electrical short.

If you need help with water damage restoration, Baltimore, Maryland, contact us today at MD Water Damage Restoration. We offer free estimates and 24/7 immediate response.